Bondage Bra
made by circe
The pictures above show the two most common methods of tit bondage, the tight ball and the harness. Not all breasts are suitable for either of these methods. Small breasts or breasts that extend too far to the sides cannot keep the rope in place for success in binding them in this way.
This simple bondage bra solves the problem.
You will need :
Piece of string for measuring
Ruler
2 embroidery rings
1 length of rope 20" long
4 lengths of rope 40" long
Seat belt comfort pad (optional)
NB: Rope lengths will of course vary from person to person |
 |
To take a quick breast measurement hold up and grip one breast as firmly as you can and with your other hand run a piece of string tightly around it. Measure the string from the point both ends meet. This will give you a tight circumference measurement. Mine was unimpressively 14".
However, embroidery rings are measured by diameter, the measurement across a circle from one side to the other. Whilst I had a room full of people deftly using pi as the ratio of a circle's circumference to its diameter to find the figure for me, I laid the piece of string on a table in as near perfect a circle as I could and used a ruler to measure across. This gave me the diameter measurement of 4½".
Embroidery rings come in whole figures so I had a choice between 4" and 5". This measurement was the diameter of the space across the inner ring and for this bra you only need the outer ring so 4" was perfect. Just to make sure I placed both size rings onto my boob over my T-shirt. The 5" went completely over the breast which meant it was too big to be restrictive, but the 4" crowned it just right.
Note : If you try this be sure to wipe off the mark left on your T- shirt before turning to face the rest of the shop!
Discard the inner rings of both embroidery rings. The outer ring of wood has a screw adjustment on it. Open this out as far as you can.
Take the 20" piece of rope and loosely tie the two rings together, space them to roughly match your breasts. Use the 4x40" pieces to make the left and right straps to tie at the back and the two straps to tie as the halterneck.
Tie the whole bra into position. Tie the back strap quite firmly but leave the halterneck as a loose tie.
Work your boobs into the rings as far as you can, and then a fraction more. Hold each one as you close up the screw adjustment
Once the boobs are in the rings tighten the piece of string at the front to pull the breasts together and tighten the halterneck to lift them.
|
The halterneck knot might dig uncomfortably on the
back of the neck so it is worth buying a car
seat belt pad to fit around the rope at that point.
|
|
